How do you reset the security system on a 2008 Pontiac G6?

Contents show

How do you reset the security system on a Pontiac G6?

1 Answer

  1. Sit in your car and ensure all doors are closed.
  2. Put the key into the ignition while holding the lock button on the driver’s door.
  3. Turn the G6 key in your ignition from “On” to “Off” while holding the “Lock” button, and do two more cycles of “On” and “Off” in quick succession.

How do I get my Pontiac out of theft mode?

The keyless entry remote and the ignition key are required to reset the anti-theft system.

  1. Exit the vehicle and stand next to the driver’s side front door. …
  2. Press and hold the lock and unlock buttons on the keyless entry remote until the horn honks once and the lights flash briefly.
IT IS INTERESTING:  Do domain controllers have a local security policy?

How do you reset the security system on a 2009 Pontiac G6?

–Turn the ignition key to the Run position. Note the security indicator lamp. It may flash for a few seconds, then turn on solid. It will remain on for approximately 8 to 15 minutes.

How do you reset a 2008 Pontiac G6?

Instructions:

  1. Turn the ignition to RUN (second position)
  2. Press the INFO button to scroll until the Oil Life displays.
  3. Press the MENU and ENTER (arrow) buttons at the same time to display OIL LIFE RESET.
  4. Press and hold the ENTER (arrow) button until the cluster shows ACKNOWLEDGED.

How do I get my car out of anti theft mode without remote?

Resetting the Alarm

  1. Close all of your car doors.
  2. Insert one key in the door lock and cycle it to the “Lock” position, and then back to the “Unlock” position two times. …
  3. Enter your car and insert your key into the ignition cylinder.
  4. Cycle the key in the ignition from the “Off” position to the “On” position twice in a row.

How do I bypass PassLock GM security system?

Thankfully this is an easy fix.

  1. Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
  2. Look at the dashboard and locate the theft system light. …
  3. Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.

How do I reset my anti-theft system?

Leave the key in position for about 10 – 15 minutes. Step 3: Check the anti-theft light again. If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two. This gives the system time to reset or you won’t be able to start your car.

IT IS INTERESTING:  What is system security explain?

What triggers theft-deterrent system?

The theft-deterrent system in your vehicle may be triggered by the following: Key learning (copy of key made) Forced entry alarm (door, trunk, hood) … Charging alarm (electric vehicles only)

How do you reset the security system on a 2005 Pontiac G6?

Turn ON the ignition, with the engine OFF. Attempt to start the engine, then release the key to ON (vehicle will not start). Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF. Turn OFF the ignition, and wait 5 seconds .

Why is my Pontiac G6 not starting?

While there are a variety of reasons your Pontiac G6 won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.

How do you turn off the alarm on a Pontiac G6?

Re: how to disarm a Pontiac G6. Go into your settings on the radio and change it to RKE. The alarm will beep when you unlock the doors via your keys but stop once you turn the ignition on, the alarm will not arm unless you lock your doors either.

What does Service Tire Monitor mean on a 2008 Pontiac G6?

Your Pontiac G6 is equipped with a tire pressure monitor system. This system notifies you if the tire pressure is too low. When you get the Service Tire Monitor warning, it indicates that there is a problem with the tire monitoring system itself.

How do you reset the check engine light on a 2007 Pontiac G6?

A few different ways to reset your check engine light are:

  1. Let it go off by itself.
  2. Turn your ignition on and off several times in a row.
  3. Disconnect your battery and reconnect it.
  4. Buy an OBD II scanner (they’re relatively inexpensive) and follow the instructions (it’s pretty easy)
IT IS INTERESTING:  What is a protected rights investment account?

What should the tire pressure be for a Pontiac G6?

Recommended tire pressure for Pontiac G6 tires is 30 psi to 32 psi, set by Pontiac manufacturer and based on model’s original equipment tire size to optimize vehicle performance, fuel efficiency and safety.