The PROTECT and PUSH POWER messages will flash alternately when the protective device of the amplifier has been activated because a strong signal was input, or if there is a short-circuit detected. To resolve the issue, turn the amplifier off and leave it off for at least 30 minutes.
How do I fix push power protect?
PUSH POWER / PROTECT / PROTECTOR is flashing in the display of the home audio device.
- Turn off the home audio device, and remove all speaker wires from the back. Then turn the device back on and check if the issue is resolved. …
- Inspect the speaker cords. …
- Make sure the speaker impedance is within the recommended range.
How do I reset my push power protector?
To reset the internal surge protection circuit unplug the AC power cord from the wall for at least 30 minutes. Ensure the top of the home audio device has proper ventilation to keep it from overheating. Running the home audio device in a poorly ventilated cabinet can trigger the protection circuit.
What is the meaning of push power?
to apply steady force to (something) in order to move it. 2 to thrust (one’s way) through something, such as a crowd, by force.
Why does my Sony receiver go into protect mode?
If you’re wondering why “my Sony receiver is flashing protect,” it’s likely related to a short circuit or a power surge. Once the protect mode is activated, the speakers will not function until the threat is removed. The best first course of action is to simply turn everything off and wait while the system cools down.
How do I unlock my Sony home theater?
Follow these steps to unlock or release the tray:
- Turn on the Home Theater System.
- Press the STOP button and the EJECT button simultaneously for five seconds.
- The message UNLOCKED will be displayed to indicate that DVD disc tray is unlocked.
How do I reset my Sony DVD at home theater?
How to reset the DVD home theatre system to the factory default specifications.
- While the DVD player is in the stop mode, press the DVD SETUP button.
- Press the UP ARROW or DOWN ARROW to select SETUP .
- Press the ENTER button.
- Press the UP ARROW or DOWN ARROW to select RESET .
- Press the ENTER button.
How do I reset my Sony S Master Digital Amplifier?
Unplug the power cord and confirm that the STANDBY indicator is not lit. Then pluh back in the power cord and turn on the system. At the same time, press and hold the FUNCTION and ON/Standby buttons until RESET appears on the display window.
Why does my stereo say protect?
Your stereo receiver is going into protection mode because the receiver has an internal short, a speaker is bad or the speaker wiring has a problem, such as incorrect wire gauge or bad connections.
Why is my Sony surround sound not working?
Try different cables to verify this is not a bad set of cables. Try setting the Audio/Video (A/V) receiver to a different Surround Sound mode. … Check each speaker to make sure they are properly connected to the A/V receiver. Perform a Test Tone function to verify if the speakers are working correctly.
How do I get my stereo out of Protect Mode?
Turn off the receiver and let it cool for a few hours; then try again. If the protection mode warning doesn’t go away on its own, press the reset button. If that doesn’t work, disconnect the power lead from your receiver for 30 seconds and then reconnect it. If it still doesn’t work, it’s time to take it to the dealer.